SEALING AND PERMANENTLY PROTECTING RESILIENT FLOOR COVERINGS WITH UZIN TURBO PROTECT PLUS.

UZIN Turbo Protect Plus has been specifically developed for resilient floor coverings. Through the 2-component PU coating, a new and extremely hard-wearing protective layer is applied to the existing floor covering. That means that the renovated resilient flooring can be used again without any restrictions for several years.

This Renoplan system is perfectly suited for properties, in which a costly replacement of the entire floor is not possible due to time reasons. Likewise UZIN Turbo Protect Plus can also be used for long-term protection for newly installed resilient floor coverings.

Download Flyer (PDF)

Processing film: Sealing and permanently protecting resilient floor coverings.

Image gallery: Sealing and permanently protecting resilient floor coverings.

The floor covering must be thoroughly cleaned before sealing. Use a vacuum cleaner to remove any contamination from the surface. Then apply the UZIN Basic Cleaner, depending on the severity dilute between 1:10 – 1:1 with water.

Apply the correctly diluted solution on to the floor with a mop and allow to sit on surface for 10 – 20 minutes. Do not allow to dry.

Clean the floor with a cleaning/buffing machine with a suitable pad, e.g. RZ pad grey.

Remove dirt and liquid residues with a wet cleaning machine or a water vacuum. Clean the floor twice with a clean microfibre mop and clear water. Allow to dry.

Shake Component A vigorously for at least 2 minutes before adding Component B. Add Component B to Component A (1 : 4 mixing ratio) and shake immediately and vigorously for at least 2 more minutes. Only then insert the plug-in filter into the canister of component A.

Apply the UZIN Turbo Protect Plus mixture around the parameter. Apply evenly with a small microfibre roller under light pressure.

Beginning in one direction, apply the sealer with the UZIN Turbo Protect Roller. Cover every part of the floor with the coating. To finish roll over the coating again but at 90 degrees to the previous direction. Avoid puddling. At 20°C / 100 ml/m² the floor may be walked on after 12 hours and is lightly loadable after 1 day. The curing process takes approximately 7 days.

With UZIN Turbo Protect Plus, the floor covering is given
a highly resilient and value-preserving sealing, which makes
cleaning easier in commercial and industrial areas.

Frank Zaumsegel
UZIN application technology